Automatic Technology Australia GDO-2 SecuraLift Guide de dépannage télécharger pdf (Page 23)

Owner Installation Instructions GDO-9v2 SecuraLift

Step 22 - Fitting the P.E. Beams (optional)

Afﬁ x the P.E. Beams in a strategic location within

the doorway. We recommend 150mm above the

ﬂ oor level and as close as possible to the door

opening, inside the garage.

Remove the shunt from P.E connector (Fig. 39).

Connect the wires from the P.E. wiring harness to

terminal block (Fig. 40). The wiring diagram is for

Model PHBE (Order Code 90214).

Make sure to align the beams correctly. Follow the

manual supplied with the P.E. Beams.

WARNING: When using Auto Close Mode and P.E.

beams, the doorway must be clear of all obstructions

and persons at all times. The location of the beam

sand manner in which it is installed might not give

safety protection at all times. Check to make sure

that the height of the beam and type used give

maximum protection possible.

Step 23 - Setting Up Auto-close Mode

IMPORTANT NOTICE: It is compulsory to have P.E.

Beams installed when using Auto-close mode.

Auto-close mode is a function that automatically closes

the door a preset time after the P.E. Beams recognise

that a vehicle has left the garage.

The Auto-close timer only starts after the P.E. Beam’s

path is broken the Auto-close timer has been set. If

the P.E. path is not broken the door will remain open

until the path is broken. If the opener incurs a physical

obstruction (i.e. not from the P.E. Beams) while closing

the door will re-open and not Auto-close until the P.E.

Beam’s path is broken again.

Step 23.1 - Setting Auto-close Time

Hold down the AUTO CLOSE TIME button (Fig. 30).

While holding in the AUTO CLOSE TIME button,

press the PLUS (+) button - each press will add

one second to the Auto-close delay.

To decrease the delay time follow Step 15.1(a)

and press the MINUS (-) button - each press will

deduct one second from the Auto-close delay.

Press the OPERATE button or transmitter to open

the door. When the door is fully opened the

OPEN LIMIT LED will ﬂ ash to indicate that Auto-

close mode is operational.

Break the P.E. Beam’s path momentarily to

initialise Auto-close. When the door reaches the

fully opened position, the door will pause for the

set Auto-close time and then close.

P.E. Beam & Auto-Close

12 345

Remove

PE shunt

Receiver

Transmitter

Cable 1

Model PE-2

Cable 2

24V

LGT

OSC

COM

Red 24V

Black 0V

Yellow PE

ﬁ g

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Automatic Technology Australia GDO-2 SecuraLift Guide de dépannage Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Automatic Technology Australia GDO-2 SecuraLift